Offshore Technology Research Center

 

Abstract ID# :

A192

Report Title:

Non-Linear Load-Deflection Models for Seafloor Interaction with Steel Catenary Risers

Authors:

Yaguang Jiao, Texas A&M University

Report Date:

May, 2007

The simulation of seafloor-steel catenary interaction and prediction of riser fatigue life required an accurate characterization of seafloor stiffness as well as realistic description of riser load-deflection (P-y) response. This thesis presents two load-deflection (P-y) models (non-degradating and degradating models) to simulate seafloor-riser interaction. These two models considered the seafloor-riser system in terms of an elastic steel pipe supported on non-linear soil springs with vertical motions. These two models were formulated in terms of a backbone curve describing self-embedment of the riser, bounding curves describing P-y behavior under extremely large deflections, and a series of rules for describing P-y behavior within the bounding loop.

The non-degradating P-y model was capable of simulating the riser behavior under very complex loading conditions, including unloading (uplift) and re-loading (downwards) cycles under conditions of partial and full separation of soils and riser. In the non-degradating model, there was a series of model parameters which included three riser properties, two trench geometry parameters and one trench roughness parameter, two backbone curve model parameters, and four bounding loop model parameters.

To capture the seafloor stiffness degradation effect due to cyclic loading, a degradating P-y model was also developed. The degradating model proposes three degradation control parameters, which consider the effects of the number of cycles and cyclic unloading-reloading paths. Accumulated deflections serve as a measure of energy dissipation. The degradating model was also made up of three components. The first one was the backbone curve, same as the non-degradating model. The bounding loops define the P-y behavior of extreme loading deflections. The elastic rebound curve and partial separation stage were in the same formation as the non-degradating model. However, for the re-contact and re-loading curve, degradation effects were taken into the calculation.

These two models were verified through comparisons with laboratory basin tests. Computer codes were also developed to implement these models for seafloor-riser interaction response.

To obtain a copy of this report send an email request with the Abstract ID and Title to info@otrc.tamu.edu

©2013 All Rights reserved Offshore Technology Research Center